FM-8000T, DigiFlow Digital Water Flow Meter Rate Count Down

Digital Flow Monitor  (counting down, alert)   Made by Digiflow USA

• Counting down: set a volume in gallons then it starts counting down when water passing through it.  It will beep at the end of countdown. Counting down from: min 100 gal;  max 9900 gal.

• Elapse time: counting down, counting down from: min. setting 30 days,  max setting 720 days.

• Real time Flow rate: range 0.4 to 3.7 GPM (gallons per minute)  

• Minimum flor rate must be 0.4 GPM and up.

Model: 8000T -G  (gallon model)   (internal part no. FM-8000T)

• Volume capacity monitor:  min. 100,  max. 9900 gallons (counting down)
• Elapse time monitor:  min. 30 days,  max. 720 days
• Flow rate display from 0.4 gallons per minute to 3.7 GPM
• Connection:  3/8” NPT, + Bonus fitting:  two 1/4" fitting and two 3/8" fitting (fits 1/4" OD tubing and 3/8" OD tubing)
• Electrical:  3 DC Volt (two AAA battery)   1.0mA (display mode) 0.05mA (idle)

Audible alert:  beeps near the end of countdown and beeps at the end of countdown

• Low battery power alert
• Display is auto-off after 10 seconds
• Automatic data saving when battery is out
• Reset button:  press and hold the button for 5 sec. to reset to zero

Material:

• Sensor body: Acetal copolymer, TICONA M90
• Turbine:  Acetal Copolymer
• Turbine shaft: #304 stainless steel
• O-ring:  EPDM Rubber
• Housing:  ABS resin

    Specification:

• Dimension: 2 7/8” x 2 3/4" x 2”
• Operating temperature: 40F to 172F  or 4 C to 80 C
• Max operating pressure: 85 psi or 6 bar
• Accuracy: +/- 10%